New Reviewer - equk
"Hi, I'm B.Walden AKA equk on the forums. I was amazed when I heard OC3D were looking for new reviewers. Within minutes of reading the news I had sent off an email with all of my details, links to articles I had written & almost my CV. "
Published: 14th May 2007 | Source: Overclock3D |
Note from the Editor
We felt it was time to bring something new on board and after having a good look at all the applicants we thought Bradley had what it took! So...welcome equk on board!
New Reviewer - equk
Hi, I'm B.Walden AKA equk on the forums. I was amazed when I heard OC3D were looking for new reviewers. Within minutes of reading the news I had sent off an email with all of my details, links to articles I had written & almost my CV.
I hope I can do OC3D justice as I know there are some amazing people on the team already. I already know a few of them quite well from being in the OC3D CounterStrike Source Clan.
I look forward to writing articles in the future and hope I will live up to the high standards already set by the previous reviewers.
Discuss and congratulate here
Most Recent Comments
I've finally got my setup installed (bare without any of my goods in the case) it's a naked Lian-Li PC-65 with all the tubing connected. I do have a reservior, and would like to begin the leak test tommorow. The only question I do have is... if I need to drain the distilled water out, how will I do it? Also I have MCT-5 but was wondering if it's a concentrate (do i need to add distilled water) or pre-mixed?
Let me tell you something. MCT-5 is a BETTER conductor than water. Do you have any iodine stuff at home? Use straight water, plus some biocide, and maybe dye.
ermmm........pull a hose off and drain?
you got a T-line somewhere at the bottom of your loop?
you got a T-line somewhere at the bottom of your loop?
i do have iodine. for my salt water fish tank. but erm, i'm trying to figure out how to drain the liquid when I have my components in there. (for maintainance. such as a drain valve or some other sort. Any suggestions? I noticed that koolance has a kit, but does not have 1/2 size. btw: any pics on how the T section is installed?
If you want to see a 'T' section then have a look here (4th pic down in front of the pump). It's designed to facilitate easier filling and emptying of the loop.
i do have iodine. for my salt water fish tank. but erm, i'm trying to figure out how to drain the liquid when I have my components in there. (for maintainance. such as a drain valve or some other sort. Any suggestions? I noticed that koolance has a kit, but does not have 1/2 size. btw: any pics on how the T section is installed?
I suggest you remove all that MCT s*** and fill your system with distilled water, and add some of that iodine.
Draining liquid? Just tip the res over...into a bucket or something
yeh just put the res in a bucket on the floor lower than all the other components and all the water should drain. :D
CSS Valid