Adding a top mounted Window and Fan
Method continued...
Published: 13th April 2006 | Source: Overclock3d |
Now it's time for the rubber gasket installation.
Start by pushing the moulding around the the metal of your panel window, and continue working your way around the entire window until it's done. Next you can peel off the protective paper that is on your plexi glass.
It's a good idea to just peel back only 2 inches or so from the edges. This prevents the plexi glass from being scratched during the rest of the installation process. The moulding should be a little long, just trim off the extra molding with a knife until the length is just the right size.
Work your way around the hole, pushing the window into its groove. Use some masking tape to hold the gasket firmly in place to ensure a tight fit.
Start by pushing the moulding around the the metal of your panel window, and continue working your way around the entire window until it's done. Next you can peel off the protective paper that is on your plexi glass.
It's a good idea to just peel back only 2 inches or so from the edges. This prevents the plexi glass from being scratched during the rest of the installation process. The moulding should be a little long, just trim off the extra molding with a knife until the length is just the right size.
Work your way around the hole, pushing the window into its groove. Use some masking tape to hold the gasket firmly in place to ensure a tight fit.
The tighter you can get the rubber moulding back, the easier the process of installing the window will be.
Most Recent Comments
Thanks Ionicle, the thought is appreciated regardless :)
Page down? :(
http://www.overclock3d.net/articles.php?type=3&id=42&page=1&desc=adding_a_top_mounted_window_and_fan
Homepage got a makeover, as did the URLs.
Homepage got a makeover, as did the URLs.
Out of interest, as i am planning to give my Aplus CS-188AF a top window, as the side fan makes a decent side window near impossible, where can i get hold of rubber moulding strips from the UK? can anybody link me too a site? i am i think, right in saying that i can get the perspex from a building merchants?
If U Dont Mind Checking The Link ! it looks dead to me :D
thanks mate :)
thanks mate :)
http://www.overclock3d.net/articles.php?type=3&id=42&page=1&desc=adding_a_top_mounted_window_and_fan
Homepage got a makeover, as did the URLs.
see above
link needs fixage :)
edit: found it :D
edit: found it :D
p
CSS Valid